1. Breakdown voltage V (BR), 2. Maximum reverse pulse peak current IPP
Categories：Product knowledge Date：2024-12-05 Hits：285 View »
Schottky diode is a special type of diode characterized by low voltage drop and fast switching speed.
Categories：Product knowledge Date：2024-12-04 Hits：271 View »
The diode mode is mainly used to measure the forward voltage drop of the diode, while the buzzer mode, also known as the on/off mode, is mainly used to measure the continuity of the circuit. Some multimeters combine the buzzer mode with the diode mode, while others separate these two modes.
Categories：Product knowledge Date：2024-12-04 Hits：297 View »
The reasons for the inconsistent voltage drop of the four diodes in the rectifier bridge may be the following:
Categories：Product knowledge Date：2024-12-04 Hits：273 View »
A rectifier bridge typically consists of four electrodes, two of which are positive (Anode, marked as AC,~or arrow) and the other two are negative (Cathode, marked as -, - or circle).
Categories：Product knowledge Date：2024-12-03 Hits：281 View »
TVS (Transient Voltage Suppressor) tube, also known as Transient Voltage Suppressor diode, is a new type of high-efficiency circuit protection component invented on the basis of Zener diode technology. The core advantages of TVS tube are p-second response time and high surge absorption ability.
Categories：Product knowledge Date：2024-12-03 Hits：303 View »
Silicon carbide is an inorganic substance with the chemical formula SiC. It is produced by high-temperature smelting of raw materials such as quartz sand, petroleum coke (or coal coke), and sawdust (salt needs to be added when producing green silicon carbide) through a resistance furnace. Silicon carbide also exists in nature as a rare mineral, moissanite.
Categories：Product knowledge Date：2024-12-03 Hits：299 View »
When using a voltage regulator, we need to pay attention to the following aspects. Firstly, it needs to be reversed in the circuit to stabilize the voltage. That is to say, the negative pole of the voltage regulator is connected to the high potential in the circuit, and the positive pole is connected to the ground potential. If it is reversed, it will burn out the voltage regulator due to excessive current.
Categories：Product knowledge Date：2024-12-02 Hits：274 View »
The band gap of silicon carbide is 2.8 times that of silicon (wide bandgap), reaching 3.09 electron volts. Its insulation breakdown field strength is 5.3 times that of silicon, up to 3.2MV/cm, and its thermal conductivity is 3.3 times that of silicon, at 49w/cm · k.
Categories：Product knowledge Date：2024-12-02 Hits：270 View »
With the upgrading of consumer electronics functions and the continuous increase in usage in the new energy vehicle manufacturing industry in recent years, the demand for upstream passive electronic components such as surface mount diodes has gradually increased. Especially after strong support for the development of new energy vehicles, the market's demand for surface mount diodes and voltage regulator electronic components has become even greater.
Categories：Product knowledge Date：2024-12-02 Hits：273 View »
